The Toneprint App gives you the option of marking any Toneprint you like for a specific pedal as a favorite.  The issue is, if you go back and look at the favorites you marked for the different types of pedals you have, you are presented with a long list of items which appear to be default sorted based on the Toneprint name rather than, say, the pedal type (e.g. chorus, delay, etc.). 

So, for example, if you just want to look at ONLY your Hall of Fame Reverb favorites, you cannot do so.  Rather, all of your reverb favorites are lumped in with your chorus, tremolo, and delay favorites, and unless you remember the specific favorite name, you'll have to wade through the list of ALL of your favorites until you find the one you want.

Suggested Toneprint App enhancement: Allow for the sorting/filtering of toneprint favorites based on pedal type.  Query example: show me all of my delay favorites; show me all of my chorus favorites, and so on.

Morning all, 

Need some advice on my new TC set up. 

I have a BQ250 and 2 BC208 bass cabs. Am I right in thinking that when connected the overall speaker load becomes 16 ohm, or are the rear unputs on the cabs parallel connectors making the cabs go to a 4 ohm load which perfectky macths the head and wattage.

There is only 1 speaker output on the reverse of the amp so i have to dasiy chain the cabs

Was reccomended this setup but then thinking connecting 2 8ohm speakers in series makes  a16 ohm load which to my knowledge doesnt really produce its maxium volume potential.

This make sense? Or shoul I have just bought 1 single 4 ohm speaker. 

Hello.

Bought a new Vortex flanger and connected it to PC (Win 10) and/or Android. Both devices recog. the pedal. I can send artist toneprints to it - that works fine.

I can not build own toneprints. The software says "connect your TonePrint product to your xydevice..." Well, it is connected - i can send toneprints...

But i want to create own toneprints. Why is that not working?

Cheers

Wolfgang

Hi guys has anyone used the meloaudio midi commander with the voicelive3 to control either guitar effects or the looper functions any help would be much appreciated the only info I can find on which pedals can be used on the voicelive 3 is the tc helicon 6 switch cheers. 

I just recieved the Ditto + and upgraded the firmware right away.

When I press record in either regular or extended mode, the volume increases quite a bit. The playback volume is also increased.
The pedal was working normally one day and the next, it started with this unusual volume increase when I hit record and play.
I reinstalled the firmware but that made no difference. 

Is there something I can adjust or is the pedal broken? 

Note: The volume knob doesn't change the record level. 

I am using a pmp560m with passive speakers and I want connect a XENYX 1622FX with powered speakers to it so i can use the  mic inputs and powered speakers as  floor monitors  can this be done ..if so is there a diagram that shows how this is done

thanks 

Joe (electronic drummer)