When can we expect x32-mix to be updated to work with all the functions that came with firmware 4.0? Or is it that wings Co-pilot is taking all the focus?
And yes, I know that older version of x32-mix works fine with new firmware and that I can use Mixing station instead of x32-mix.
First of all, you're doing an amazing job! The Wing is incredible for features/money. I've used it live, in a remote recording situation, and as a DAW controller. The only 2 things I really wish I had at my disposal are 2 FX emulations - I'm missing an LA-3A and some kind of pitch correction. Any chance we may get these in future updates?
Thanks!
In section 9 of the Behringer X18 manual (specifications), it lists the aux outputs of the X18 as "6 TRS, balanced impedance". I have a few questions regarding connecting the X18 aux outputs to unbalanced inputs:
- Is "balanced impedance" the same as an impedance balanced output with the cold out connected only to ground with a resistor?
- Is it okay to short ring to sleeve with a TS to RCA cable to send the aux output to an unbalanced input?
- Should I be using an active electronic convertor such as the ART CLEANBoxPro Balanced / Unbalanced Convertor?
- Should I be using a passive isolation transformer system such as the ART DTI Hum Eliminator?
- Should I be using a passive isolation transformer system similar to the ART DTI Hum Eliminator, but also tie the balanced and unbalanced ground together?
Thanks
Hello, when i open X-Air edit in windows it just crashes. I have found the folder where "X-AIREdit.init" is stored and when I delete that file it allows the program to open. When i close the program and go to open it again it crashes. I have to delete the file again. That file stores the last used mixer settings. When iI delete that file I have to sync from the mixer to the pc to get all my setting back. I can do this process every time but it shouldnt have to be like that and I am getting frustrated.
Can anyone tell me if I can connect and control the X18 from two separate ipads at the same time so each band member can control their in-ear monitors?
Thanks!
Is there a copilot version that works on android 8.1 ?
I have one channel on my x32 that isn't going out to the mains. I can't figure it out.
Yet it is not going to the mains. I am mystified and don't know what to check?
Thanks,
Kirk
Hi, I have had my x32 rack for about 8/9 months now and I was using it for recording yesterday when all of a sudden it just shut off....
It powers on, just. I have to leave it a minute to power on but once it has done that, non of the inputs work. I've tried changing routing, updating firmware etc. and im not getting any signal from my microphone. What should I do?? I don't have my warranty info anymore because I didn't expect anything like this to happen within the first year at all and I can't just ring behringer either.
when connected to the mac via usb nothing. when using a cat 5 nothing, what gives?