Statistics

298,544 members
182,157 posts
  • Sven2453
    Newcomer - Level 1
    2022-09-19

    I have a Ip1000v1 that has been extremely consistent but suddenly is not connecting to Bluetooth. 

    I have tried a factory reset, turning Bluetooth on and off multiple times and it is not showing up. 

    Not sure what to do next. 

     

    Pete 

    read more...
    0 1
  • New
    thosalbert500
    Newcomer - Level 1
    2022-09-03

    Hi - I own two Behringer Europort MPA30BT speakers. I've had them over five years, but havent used them for a year or so. 

    I just pulled them out to use them and it seems like (for both of them) the batteries are no longer taking a charge. 

    When I plug in the cable to charge the battery, the display lights show green (meaning "fully charged")

    But I can't get any sound out of the speaker (without the power cable). When I plug in to power and power on, the speaker works fine. So the batteries must have died. 

    So my questions are:

    How long do these batteries normally last?

    What is the best way to care for the battery so it lasts a long time? 

    Where can I find replacement batteries for the Europort MPA30BT ?

    Thank you!

    Tom

    read more...
    0 7
  • New
    DW7001mel
    Newcomer - Level 1
    2022-08-25

    I'm fixing a B115W for somebody. When I turn on the B115W the power light blinks orange any ideas what the problem could be. Before I dig into it.

    Thanks Mike

    0 11
  • New
    saifzack
    Newcomer - Level 1
    2022-08-24

    Hi everyone, as a beginner I just bought 1 set of Behringer Europort PPA500BT, so may I ask where should i get a Effect Table as guide to use Klark Teknik Multi-FX Processor preset?

    Sorry for asking, because I can’t find anywhere.

    Here i'm attached pic as example.

    Thank you very much for any help.

    read more...
    0 18
    • saifzack
      Dale_M Thank you for your inquiry, I have checked the QSG documentation and it appears to have been missed, I will see if this can be corrected.
      • Aug 23
    • saifzack
      saifzack Thank you for your respon..so where should i get the effect table
      • Aug 27
  • New
    aruizj
    Newcomer - Level 1
    2022-08-01

    Guys need your suggestions: It seems like I have a faulty electrical ground connection (I think is on my Cable TV provider side), and my loudspeakers, pick up the noise. Any recommendation on how to deal with it? I have a pair of 12" Behringer. Thanks for your suggestion and recomendations.

    read more...
    0 4
  • New
    genging
    Newcomer - Level 1
    2022-07-26

    Please share how to connect pair 2 PK115A speakers, output stereo sound,  I get sound from bluetooth.

     

    FROM Spec: A speakON speaker output connector allows the PK115A to power most passive 8-ohm speakers such as the PK110 or PK112. For a true stereo L/R operation, two PK115As are needed with each to receive independent the left and right signals respectively.

    read more...
    1 7
  • New
    Behringer
    Triber Moderator
    2022-07-26

    SAT Series
    https://www.behringer.com/series.html?category=R-BEHRINGER-SATSERIES

    Learn More:

    SAT 1004 BUNDLE
    https://www.youtube.com/watch?v=6Eh3DBvzmgs

    SAT 1008 SUBA
    https://www.youtube.com/watch?v=RwUylvlVwJs

    SAT 1004
    https://www.youtube.com/watch?v=2H2PL13halg


    Ultra-Compact Passive Installed Loudspeakers, Active PA Subwoofers with Built-In Stereo Crossover and Complete PUB Installation Speaker Bundles with Passive PA Speakers, Active PA Subwoofers and More

    From: $59.00 (in stock and immediately shipping from our factory)

    #Behringer #SAT1004BUNDLE #SAT1004 #SAT1008 SUBA #SATSeries #Loudspeakers #SurfaceMountSpeaker #PortablePASpeaker

    read more...
    0 13
  • New
    Smithy
    Newcomer - Level 1
    2022-07-21

    Can anyone tell me where I might get a replacement "Behringer yellow logo" for the front of my 208D active speaker. Its about 62mm along the base and 43mm at the triangle apex...  Any help would be appreciated,  Cheers

    read more...
    0 16
  • New
    Dmitrii
    Newcomer - Level 2
    2022-07-20

    Hi, 

     

    please prompt - when using extension output of Behringer PK108A to powering Behringer PK108 - will this PA will work as a stereo system or as a mono system?

    0 16
    • Dmitrii
      KyleJohnson Hello, Kyle here with Music Tribe. It would be mono, the input on the PK108A is mono and the output reproduces the same mono signal.
      • Jul 20
      • Behringer PK active series
        Dmitrii Thanks Kyle, I've read that it could power several PAs - how many exactly is allowed?
        • Jul 21
  • New
    HRAyala
    Newcomer - Level 1
    2022-07-17

    Hey, I've just became the owner of a Eurolive PMP2000 800-Watt 14-Channel Powered Mixer with Multi-FX Processor. I've been trying to find passive speakers for it, but the ones in the owners manual are outdated.  What are the current Behringer passive speakers that took the place of the B1500 & B1020 speakers?

    read more...
    0 20
    • HRAyala
      djtetei According to Behringer PMP2000 specifications, it can deliver 2x165W RMS into 8 ohms and 2x250W RMS into 4 ohms speakers, so you need 80W RMS/8 ohms or 120W RMS/4 ohms speakers.
      • Jul 19
Go to page