Hello there,

                  I had bought a pair of Tannoy Revolution R3 Floorstanding Speakers. They are Bi-Amped to a Cyrus preamp and two Cyrus Power amps.

They are standing on thick carpet in my flat, but one is leaning to one side, so I need a set of 8 speaker spikes for them.

I have looked on ebay and Amazon, but I have no idea which thread my speakers use to facilitate speaker spikes, once I know this, my search will be a whole lot easier...

I want to thank you in advance for any assistnce given.

Kindest regards,

                          Nightcast2000

I recently acquired two Tannoy VS 218 DRs. One of the bins' drivers is not working properly. I thought it was maybe the Neutrik plate on the back, but unfortunately after connecting via speaker wire directly from the amp to the driver terminals it still is giving the same poor results. There is no visible damage of any kind on the driver.

What might be the issue?

Can it be repaired?

Can it be replaced?

Hi there looking to find some specs on these speakers as there is very little on them!

I bought a pair solely after listening to them, but would be nice to know more about them. They have four tapped holes in the base but they didn't come with spikes or a plinth with spikes, I would really like to get them up on spikes instead of just being on the floor. What size are the tapped holes in the base?

What is the sensitivity of these, recommended amplifier for them? 
If anyone can help with something that would be really helpful.

TIA

Hi,

I just bought the Tannoy DMT II 215 Speakers and wanted to make sure of the connection.  I am going to use a single 500 Watt amp to power these and the SPL MTC Model 2381 Monitor and Talkback Controller.  I have the DMT II 215 manual but I would like to see a photo of the actual connection to the speakers.  Thank you.

Hi, Guys. Please, help, both discontinued monitors REVEAL 6D stopped workinh, Red LED on front, instead of GREEN. 

Inside of a amp module - no smell, no phisycal damage, all ports are connected. Any idea. If the amp repair is big problem, how about to squees, for example, amp module of GOLD 8, or some other crazy idea?

The only I have a chance to check an output voltage from power transformer - smth about 24v and 52v.

THANKS

Hello Guys, please could you help if you have experienced no power light on, on your subwoofer Tannoy TS2.10. It is already 2 years I bought this subwoofer. I already checked the power cable and the fuse in the power plug and both are working.

Could you please advise how can I fix this issue or if it is possible to send only the electronic plate of the subwoofer for repair.

Thank you 

Best regards,