Hi there! My name is Thanos and I'm a sound enginieer-designer and I'm using the midas DP48 personal monitor for three months now and I'm satisfied. The problem is that the musicians need the mute function sometimes because I'm changing the inputs from the midas DL32 stagebox or I'm changing the instruments. Everytime I warn them to turn off the master volume because the mute function does not exist. Is there something better than this??? Is it available a firmware update with the mute function???

We are currently using firmware v1.4 on our 4x DP48s. Can someone point me to a full revision history from v1.4 to the latest v2.0. I can only find revision history for v2.0. Is there a full user manual to go with this firmware? All I can find is the quickstart guide and that is for v1.3 of firmware.

Has anyone update to this firmware version and can vouch for it's stability/reliability?

I have a HoW installed M32R connected to a DL16 stagebox thru AES50-A.  How do I configure AES50-B on the DL16 to send to the daisy-chained DP48s used as IEMs on stage? Currently, the DP48s are connected directrly to the M32R on AES50-B on a CAT5 mess along the floor edge. If I could run the DP48s off the AES50-B from the DL16, I would be able to avoid running cable thru the ventilation system, crawl spaces, walls, and drop ceiling to get to the DL16 in the rack at FOH. Will the Hub4 do this or is there a more economical solution?

Hi,

I noticed i can only assign an aes channel once to a group. When assingning the same channel to a second group it dissapears from the first group.
This is logical but.

When i want to use the DP48 for  two musicians it could actually be helpfull to assign  the channels to 2  different groups.
Because then user 1 can use group 1 for (example) drums and adjust the individual channels to his own flavour. User 2 can use group 2 for drums and adjust the individual channels for his own flavour.

Is there a possibility to change this in future firmware?

Willem

Noticed this recently that when I switch off a DP48 with other units daisy chained to it, the downstream unit will produce a very loud pop sound in the headphones output even though the Volume knob has been fully lowered.

I noticed it because I could hear the pop from the headphones connected to another unit that was almost 2 meters away when I switched off 1 unit for firmware upgrade and testing.

Once again the volume level has been fully lowered on that downstream unit yet the pop sound came through so loudly and this happened consistently.

What will it do to a musician with in-ears when another musician upstream switches the unit off, by accident or for whatever other reason?!

Please fix this soon.

Folks:

I'm trying to make my new PM-1 personal monitor work, (plug in) to the Air XR-18 board, as my band currently uses this system.  In reading the manual for the PM-1, it's highlighting that I would need to use a quarter inch TRS cable end in order to have a stereo feed to the device, but other than the "phones" output on the board, all the other monitor feeds are a male ended XLR output.

Would a standard XLR cable work with this in stereo, or do you have a suggestion on the type of cable I should be using here to produce a stereo sound field?

Thanks,

Tom DeMartino

[email protected]