Hello,
Just received my DN9650 and KTDante64 card and I've been trying to get things to interface with my Pro2.
I have the Pro2 connected to my DL251 via AES50 on ports 1&2. I'm using AES50 ports 4, 5, & 6 to connect to the DN9650. I have adjusted settings in the DN9650 configurations page and things look like they are showing up correctly and everything is recognized by the Pro2.
When I open up Dante Controller, I can only see the DN9650 when I click on the "Device Info" tab and then I can double click it and what it tells me is that it is "retrieving model information - please wait.." It has been attempting to retrieve this information for well over an hour at this point with no changes. I have checked all of my IP addresses and everything is in the 192.168.1.xxx range, I have removed unnecessary things from the network to try and keep things minimal and be able to locate where the problem might be occurring.
I would love some help and/or opinions on the matter.
Hello,
I'm trying to submit a Technical Support Care Ticket for my DN32-LIVE Card which is in my Midas M32R Console.
But always when I try to submit it, at the very bottom it says: "Please Fill Required Fileld"
(Also seen in the Attachment)
Can someone please help me what am I doing wrong?
Hi,
I own a pair of KT-2As (and 76-KTs) and wanted to ask two questions.
1) Upon using stereo link and calibrating the two units with a 1khz test tone, using the Stereo Link trimmer at the back to get the same amount of gain reduction, I get different amounts of gain reduction between the two units when I move the Peak Reduction. The test tone is a mono signal sent to two outputs of my soundcard. No faders hhave been touched in my soundcard's mixer, the stereo output pair I am using on my soundcard, shows the same signal between the two outputs I am using for Left and Right that are the inputs to the KT-2As.
So I am using them unlinked which is fine, but the bottom unit in the photo, needs to have the Peak Reduction pot much more CW than then top unit to show the same amount of gain reduction. How do I go about calibrating the unit so that it behaves like the top one?
2) My units are running hot. I can put my hand on them, but they are very hot.
Do other KT-2A owners experience these two behaviiours I am?
Cheers!
Hi guys,
My DN6000 has suddenly gone darker on the left side and a message saying "low battery" appeared.
I changed the battery (2430) and there is no low battery message any more but the screen is still dark on one side.
I'm attaching a pic, can anyone shed a light as to what's happening? (excuse the pun) Thank you.
1. Our MIDAS M32 was working perfectly, but recently the USB card stop working. The mac does not recognize it.
2. the issue, is not related to any update.
3.. After the failure, we update the midas m32 firmare. It did not repair the problem
4. We back to factory settings, and it did not repair the problem.
5. We remove and reinstall the card and it did not repair the problem.
6. The usb card DOES RECOGNIZE the SD cards, but not the usb port conexion.
7. We have tryed with windows and mac . The same result.
8. Does any body now what we can do?
DN200
bit.ly/Klark-Teknik-DN200
Learn More: https://www.youtube.com/watch?v=wPRcsdrHZu4
Features dual parallel-connected combo XLR’s / ¼" TRS inputs. When connecting to the Combo XLR input, the input impedance is 20 kΩ, ideal for line level equipment and offering even lower noise performance. It's also equipped with a Stereo input mini jack which is ideal for connecting MP3 players or mobiles phones etc.
List Price: $129
#KlarkTeknik #DN200 #DIBox #Active #2Channel