Statistics

249,493 members
126,504 posts
  • New
    ymichae
    Newcomer - Level 1
    2021-07-15

    Hello, I am helping out a local church with their stream setup and I am getting a buzzing noise when i select the X-card in stream labs as the source. Currently they have mix bus 3 and 4 xlr to 3.5mm into their computer which sounds horrible. I also update the firmware from 2.33 to 4.06. Can anyone look at the sence and tell me if I have the routing wrong?


    View Attachment
    read more...
    0 28
  • New
    FPCUSACNM
    Newcomer - Level 1
    2020-11-05

    Our chruch is adding a streaming camera system and I do not want to add a microphone for audio quality.  I have a Behringer SX3242FX Euro Sound Mixer and want to know if I could route the audio from the mixer to the camera software without adding a second mini mixer?  I want to have control.  I am sending the FOH feed to an amplifer and could split the output and adjust with the sofaware.

     

    Is this fessible?


    View Attachment
    read more...
    0 42
    • FPCUSACNM
      RexBeckett Hi Scott, you could use the main output from your mixer but sometimes the best mix for broadcast is not the same as that for FOH. In this case you could use Post-Fader Aux Sends to create a custom broadcast mix.

      If you don't already have one, you will need an audio interface for the broadcast PC. Something like the Behringer UMC202HD would be suitable.

      Unless the broadcast PC is close to the mixer and running from the same mains power outlet, it may be necessary to isolate the grounds in the cable to avoid hum/buzz. Something like the Behringer MicroHD HD400 would be suitable.
      • November 5, 2020