Greetings TC Electronic,

I am a proud owner of your wonderful device Studio Konnekt 48 (SK48) which I still find very useful after all these years. I’ve gone through the various driver upgrades in Windows including the 32bit to 64bit upgrade. However just recently by chance I noticed (in Device Manager) that the drivers Windows was using for my SK48 were 32-bits (below) even though I’ve already installed your 64-bit drivers years before.

1. C:\Windows\system32\DRIVERS\TCNear.sys
2. C:\Windows\system32\DRIVERS\TCNearAudiosys
3. C:\Windows\system32\DRIVERS\TCNearMidi.sys
4. .......

I've found that my SK48 64-bit driver files were in “C:\Program Files\TC Electronic\TC Near

My question is how do I make Windows 10 use the SK48 64bit drivers above rather than the 32-bit ones ?

Your advise to this is kindly appreciated.

Many thanks in advance.

Sincerely,

Phil Mark

Hi,
When I download the TonePrint manual 2.0 (frontpage attached) it look much differerent from the version that I have downloaded to my PC which is version 4.4.3. Why isn't it the same?
Is it the software that isn't updated to a new version like the one in the manual or is it the manual that is an old version?

The link in the manual that is directing you to the latest TonePrint editor doesn't work:

https://tcelectronic.com/toneprint-editor/

Best regards/
Peter