187,385 members
57,274 posts
  • New

    I have received the new Behringer 921 VCO and found the audio levels from the main outputs very low (ca 0.5V). It goes for all the main waveforms (sine, tri, pulse etc). And accross the entire frequency range.

    The aux output curiously has a 5V output level, which makes a huge difference in mixing.

    It seems very odd and I wonder if it is a faulty unit or what.

    Any help much appreciated.

    Note: There is no appropriate category for this.

    Category should be: "Modular equipment" or "Synthesizer module" or something...

    0 0
  • 2020-10-08

    My Model D analog synth was working completely fine the other day and out of nowhere it shut off. The overload button is blinking when the unit is turned on and connected to my computer, but no sound is coming out. The volume is turned up halfway on the hardware itself, all my settings are correct in Ableton. Did I break it by distorting it too much or clicking a wrong button? 

    0 6
    • Chris Nixon
      Jason Brewer Hello Chris - The unit may need service but also may need just a deeper dive. Please click on the support tab above to make a tech support ticket. We can look at repair possibility and do some deeper trouble shooting.
      • Oct 8
  • 2020-09-28

    Berhinger Ultragraph Pro mixer. Loud hum clearly coming from the mixer. This is part of a hexamped system. Preamp to active crossovers no hum.  Preamp to mixer then to active crossover loud hum in all frequency bands.  Two prong plug will not stop the hum.  


    Anyone else experienced this?. Anyone solve it?

    Not that happy with Berhinger right now. I looked for tech support and was directed to this site. Guess you out there are their unpaid techs. I hope you have an answer before I start buying in line transformers, etc. as a pray (pay) and spray maneuver.



    0 4
    • Glenn Etzel
      Kyle Johnson Hi Glenn, Kyle here with Music Tribe. This is the site that you should use to submit a Support ticket. Please click the Support button at the top of the page and submit a Support ticket.
      • Sep 28
  • 2020-09-27

    Hey guys, 

    I understand that a signal plugged into Channel One, for example, can be split into 4 channels via the Link button. My question is whether Channel One could be duplicated into 6 channels if the Link button were hit on the next row over?

    I don't yet own the equipment.


    0 10
    • jonas synthman
      Pedro Rodrigues Hi Jonas, please be aware that the LINK switches connect adjacent channels into combined pairs when pressed. Using the LINK function allows you to double the outputs for a single input signal.
      You can also use the LINK function to blend two input signals into a single, combined output signal.
      • Sep 29
    • jonas synthman
      jonas synthman Thanks for your response Pedro.
      • Sep 29
    • jonas synthman
      jonas synthman If I want to split a signal eight times with the MS8000 I guess I would either: (1) split it with another device beforehand, then plug it into Channel One and the other in Channel Five with LINK engaged on each, or (2) LINK channel one then use the output of Channel 4 to go into channel Five input, and settle for 7 outputs instead of 8
      • Sep 29