Statistics

305,402 members
189,696 posts
  • New
    acknapp
    Newcomer - Level 1
    2022-10-23

    We have an X32 at my church that we use for in-house sound. It has a Dante card in it which we use to feed (through the network) a ProTools DAW in a separate room for our live stream feed. I would like to know if there would be a way to network a second X32 (in place of the DAW) so that the person doing the sound for live streaming would have the same environment as the person doing the in-house sound.

    read more...
    0 12
    • acknapp
      GaryHiggins It would work just fine IF the second X32 also had a Dante Card installed. One simple managed network switch. Should not have to replace anything (still use Pro Tools) once set up properly.
      • Oct 24
  • New
    Dqninja25
    Newcomer - Level 1
    2022-10-09

    Hey all!

    I have a x32 and have been running it to logic to get a full mix for livestream sound. I just purchased an s32 this week and when I route it all to the board it works great but none of my signals are being sent to logic. Is there a setting I don't know about or is this a limitation of the s32?

    read more...
    0 7
  • New
    DJuanamm2021
    Newcomer - Level 1
    2021-12-16
     
    I have an online radio and I use a Xenyx FX1002 mixer with a small UCA202 audio interface (it has +12 years of use).
    
    I don't use the interface to record, the function it fulfills is the normal one (ADC-DAC).
    
    I want to buy another for the same purpose, which one do you recommend?
    read more...
    0 13
  • New
    omarnft
    Newcomer - Level 1
    2021-07-18

    We bought from your compagny this divise ULTRA ZONE ZMX2600  unfortunately last day it was stopped no output program was radiated  when i reach the transmitter site i found the said product off  i tested it it sglow for 2mn after that is shutdown please advise what we can do i trace the fault ifound that the -15v is not fixed and going to zero  we remove the connections inside the problem remain the problem ia the frontal board 

    read more...
    0 48
    • omarnft
      NicJonesMT Please click submit at the top of the page and submit a Service request case and the team will be able to advise you further.
      Just to make you aware, we do not provide any information or support for self service repairs and are not liable for any damage or injury that may occur as a result.
      • July 18, 2021
    • omarnft
      omarnft i did not found the submit
      • July 19, 2021