I bought a TC Helicon Harmony G-XT a few months ago.  During my last recording sessions it worked fine.  After writing new songs to record I hooked up the rig and now signal from the microhone to the mixer.  I thought it might be the guitar needed to be hooked up to activate the mic.  The guitar plays through to the mixer, but still no mic. 

Is there some setting that I am missing that is keeping the mic from working?  Does the mic input just stop working?  I have replaced both XLR cables with new ones and still no signal to the mixer.  What am I missing?

The mimiq is fantastic with a mono input and stereo output to two separate amps.  Love it.    But I have a truly stereo pedal board.  For example, I have a Flashback II stereo delay and a stereo chorus before the Mimiq.  If I have a nice ping pong delay or a lush stereo chorus heading into the mimiq in stereo, the effects get mashed up and lost in the Mimiq.  What are the best recommendations for using stereo inputs to the mimiq?  How is it supposed to work - ie - what's the purpose served by stereo inputs.  Am I missing something? Should I focus on keeping it in the mono chain before the stereo effects? 

I have inputted a few times care tickets for a problem with my tube mic Behringer.  However, It has come to my attention that my Hotmail account is not picking up Behringers responses, nor is it showing up in my junk folder. I posted this problem question a few weeks ago, but I could not find the response post, nor did anyone get back to me as far as I know. Suppose I open another behringer account with a new email. Can someone transfer over all my equipment registrations, so they are not lost? I would like confirmation of how my mic tube preamp problem should be handled, please. Thank you. 

I purchased a vicious vibe pedal off of eBay. Programming it to my guitar doesn't seem to make much difference. Once I beam the sound to the pickup the stumble turns red after it says it worked. Shouldn't it turn green if it was a successful beam. Please let me know if it is working correctly or it may be not working right. 

Just purchased a new SingThing and the instruction manuals (and YouTubes) seem very limited in instructions.  When I engage/change the "Effects" button, it seems that the effects are applied equally to guitar AND voice.  In other words, effects should be unique to each desired input (guitar separate from voice).  Frustrating to say the least.

Help please!?!?!

Andy

Hi There - when using a TC Ditto and other than using a Microphone or DI from the amp, does anyone know if you can record the created "loop" to an external device like an Apple computer or is the layered loop just available in the looper.

I have tried to record from the output jack but doesnt really work direct and not sure about connecting up to the USB Mini B connection as there is no mention of using this as an output but only as an input for softwere updates according to the instructions..... 

I have a Voicelive3 and am in a duo. I want my singer to have the vocal effects I have but she doesn't need to put a guitar through it. But the new device needs to know what chords I'm playing to get the harmonies right. I can provide a dual feed to both devices but I don't want the guitar to make it to the PA because that's coming from my voicelive3.

What do you suggest? A  Harmony Singer 2 Vocal Processor and Harmony Generator Floor Pedal perhaps?