Bugera

I had a problem with your customer service page. I am in Australia and I purchased a Bugera PS1 through Thomann because you have no local stock here.

I ran it for five minutes and it started smoking and spewing out a bad plastic burning smell. I'm just trying find out if this is expected or whether I am going to kill an expensive vintage amp.

I contacted Bugera/Music Tribe tech support and was told "Please be aware that you are located in an unsupported territory. This means that for further assistance you will need to directly contact the shop you purchased the unit from or your nearest reseller or distributor and they will be able to advise you further."

Not acceptable and I'm pretty sure it violates consumer law in most countries. I have plenty of Behringer gear... and I mean plenty... maybe never again after this.

Can I get some advice?

Hello.  I have attempted to replace the OEM speaker with an Eminence 820H.  It was easy enough to do, but the power going to the speaker seems much less than before.  I'm not sure what I might have done to cause this problem.  I originally tried the solderless connection using the original wire.  Then, I clipped those off and soldered it.  Same result.  The power is very low - almost non-existent at 0.1W.  At 5W, gain up and volume up, there is signal going to the speaker for sure, but it's not nearly as loud as it used to be.  

The amp is only a few months old, and it hasn't been used a ton.  So, I'd be surprised if it's an issue with the tubes.

Any suggestions on how to attack this problem?

Привет.У меня комбоуселитель bugera 333 infinium. Перестал функционировать fuswich. Работает только при включенном Fx Loop. Отдал в мастерскую на ремонт там мастер попросил у меня схему этого комбоуселителя. Можете ли вы мне отправить схему комбоуселителя?Или подсказать как устранить эту неисправность?

Hi,

Question 1

What power tubes can be used in the Bugera 1960 Infinium? EL34, 5851, 6V6, KT66, ... is there a complete list?

I already see in the faqs that removing 2 power tubes and having the amp working with only 2 is ok, under the descrived conditions.

Question 2

Is this valid for all tube types?

Some have a lower power (e.g. 6V6) and the bias can be very different, more with 2 tubes. The Infinium technology will manage but can it accommodate this bigger changes?

Many thanks

JJCosta

Hello,
Interested to buy the Bugera AC60 amplifier but before I would be glad if you could recommand me a protection cover for this AC60 model and also a portable power supply solution to use it with battery system. (internal adaptation or external solution)

Thanks for your comments and replies,

Regards

Seal20

https://booking.virtual-presence.net

I have been playing through a fender hot rod deluxe which I still love but my 62/62 is blowing my mind, using it with some tube screamers on clean and hit the dirty with one on low for screaming solos. It has become my main amp. Some day I hope bugera are associated with me like fender is with Eric Johnson or Stevie Ray Vaughn.  S.R.P. ??