Powered by .
Some translations may be inaccurate.
Powered by .
Some translations may be inaccurate DE.
Powered by .
Some translations may be left you with a question of "Arasso?".
Hi All,
I have two Behringer NX4-6000 amps with a Behringer Ultra Drive, please can someone advise on how to bridge the two amps together to give the full potential of the two amps, so its run into two channels, but also assist in programming the ultra drive.
I am using x2 Dual 18 bass bins (2000w rms per bin), and tops 1000w rms each - All 4Ohms
Many thanks,
Manni
2019-08-07
Behringer nx4-6000 Bridge mode
Hi All,
I have two Behringer NX4-6000 amps with a Behringer Ultra Drive, please can someone advise on how to bridge the two amps together to give the full potential of the two amps, so its run into two channels, but also assist in programming the ultra drive.
I am using x2 Dual 18 bass bins (2000w rms per bin), and tops 1000w rms each - All 4Ohms
Many thanks,
Manni
All the settings and connections for double bridged mode are shown on the diagrams on the back of the amp.
Thank you.
So just to confirm, you bridge channel A & B to give 3000w using xlr?
Sorry but I am such a novice when it comes to amps.