Re: X32 routing with SD8

Contributor - Level 2

It’s def not a mix issue as the attached picture I sent shows SENDS ON FADER and 9 lit up red indicating I’m in monitor mix mode and adjusting mix Bus 9. I’m using Aux inputs 5/6 for audio off my iPad for testing purposes and the fader is at -10dB on aux inputs 5/6 in Mix bus 9.

 

Still no levels or audio output.  

 

See attached picture 

Highlighted

Re: X32 routing with SD8

Super Contributor - Level 2

@Bozilla33 wrote:

It’s def not a mix issue as the attached picture I sent shows SENDS ON FADER and 9 lit up red indicating I’m in monitor mix mode and adjusting mix Bus 9. I’m using Aux inputs 5/6 for audio off my iPad for testing purposes and the fader is at -10dB on aux inputs 5/6 in Mix bus 9.

 

Still no levels or audio output.  

 

See attached picture 


@Bozilla33 

If there is no signal getting to Bus 9 it can only be a mix issue. On the last scene you posted, the sends from Aux 5/6 to Bus 9 are set to Post Fader. This means that the Aux5/6 faders on the Main LR mix must be raised before the Sends-on-Fader for Bus 9 would pass any signal. It might be easier to set the Aux 5/6 sends to Bus 9 to Post EQ to match those to the other monitor buses.