Contributor - Level 1

Euro Power PMP2000D Powered speaker connection

Hello all,

     I have a Europower PMP2000D and want to connect a powered Mackie Thump 18s to the mixer. Can anyone tell me how to do this. There is no 1/4 aux connector on the mixer, only the L/R RCA's and a FX Footsw. Would i have to run the RCA outputs (using an RCA to XLR) to the sub?

 

Thank you,

Nakoakane

nakoakane Contributor - Level 1 2019-07-07

2019-07-07

Euro Power PMP2000D Powered speaker connection

Hello all,

     I have a Europower PMP2000D and want to connect a powered Mackie Thump 18s to the mixer. Can anyone tell me how to do this. There is no 1/4 aux connector on the mixer, only the L/R RCA's and a FX Footsw. Would i have to run the RCA outputs (using an RCA to XLR) to the sub?

 

Thank you,

Nakoakane

  • 0 Kudos
  • 2 Replies
  • Reply
Contributor - Level 3

Re: Euro Power PMP2000 Powered speaker connection

Looking at the PMP 2000 spec it appears to have several jack outputs marke Monitor, Left/Mono and Right. So just use a jack to XLR lead from the Left/Mono out I would suggest.
Contributor - Level 1

Re: Euro Power PMP2000 Powered speaker connection

Hi, 

I looked again and its a EUROPOWER PMP2000D. Sorry about that.