I read through the manual but there was not a clear explanation on how to do this:
How do I setup my console so my mix bus 1 - 10 are all pre (pre-fader, pre-eq, pre dynamics).
There is a config section in the "setup" with a "Bus Pre-configuration" where I can select 10+0+6 but the 10 are set for post eq and the 6 are set for post fader. I need this for monitor sends. I will be inserting graphic EQ's from the effects section into mixbus 1-6
Under "Routing, Out 1-16" There are many Tap options (IN/LC, IN/LC + M, PreEQ, PreEQ+M, PostEQ, PostEQ+M, PreFdr, PreFdr+M, Post Fader. Not sure what these are for. Is the "M" mute?
Running my monitors from FOH (with ipad on stage), I prefer to have everything pre (just like an analog console). I assume In/LC in the signal patch is input/low cut on each channel strip
Just to clarify. For the input stage. my Home/Config (channel sends preconfiguration) should be set for IN/LC with a TEQ inserted. This should make the mixbus all pre, with the exception of the LC. The Routing/Out 1-16 should be set for Output x/ Mix Bus / MixBus 0x/Post Fader. this will make the mixbux post fader (bus 1-8 faders on the right of the console)
What does the Setup/Config (Bus Pre-configuration) do? When I select 8+0+8, mixbus 1-8 will be defaulted to Post-EQ and mix bux 9-16 setup for post-fader.
Each channel strip also has a setting in the Home/sends where the mix bus can be changed.
Do I need to make changes to all to get it to work correctly? Making changes to the Mixbus 1/home/config doesn't seem to change the mixbus setting on the channel strip home/send tab.
I currently have my tap at pre-fader and my output at pre-fader since this is how I'm used to setting up my analog consoles. I'm not sure if the monitors are affected by the channel EQ.