Specifically regarding the Combinator:
In this new XEdit I have the option of FX4L or FX4R for input at the Main's Channel tab. You can't pick both. Does it still go stereo if I pick one or the other?
I noticed if I choose in the Main, Channel, Input tab FX4L or FX4R and return to the Combinator, it shows Insert Main LR in both windows and it's turned on.
This is different from the XAir Edit where you simply choose the FX that the effect is on. There is not the option of FXL or FXR.
Gary Higgins;85031 wrote:
When I put the (stereo) Combinator as FX4 and looked at the drop down menu below it I only had an insert option of Main L/R not either or. Not the same options if I put the same effect in FX 1-3 slots-only get the word 'insert' (no main L/R). I suspect it makes no difference if you choose L or R from the Main ch menu insert window itself but I can't confirm that. Perhaps this is a bug.
Richard YClark;85039 wrote:
It is the same in any FX slot that you choose. The drop down list is for the input source to the effect, which is normally mono. Hence all the Busses and Main M/C as sources. But when selected as an Insert effect the source can be stereo for two channel effects. And the Insert label changes to that of the selected source when you enable an Insert effect on a channel or a bus (inc. the Main L/R). However a lot of the FX in the first four slots are time/delay type effects which you wouldn't normally use as Insert FX and which expect a mono source feed.
Note that the Insert points in channels and busses also list the Aux sends as destinations as well as the internal FX slots.
So it does make some sense if you can work out the logic.
Daniel Becker;85045 wrote:
I understand this. But, in the V3 version, In the Main's Channel tab, under input you only have 1 insert option not 2. Thus, the dropdown list gives a choice of FX4LCMB or FX4RCMB (See picture) (combinatory on FX4). Yet, at the Combinator it is showing the 2 options for L/R.
Does this mean, that choosing either FX4R or FX4L will still send the stereo signal from the Main through the Combinator or, does this mean one side of the Main's is going through the Combinator to then come out stereo?
Gary Higgins;85053 wrote:
I put the stereo combinator in each slot 1-4 to check. In slots 1-3, the drop down menu, the only insert option I get is "insert" In slot 4 I got "insert main l/r" assuming it reflects where it was placed...when I look at the main ch, look at the ch tab (like your jpeg) it is just one either/or option...I would still contend it likely makes no difference which you choose and probably should not have both in that menu but only a single l/r choice like the fx drop down. I too am just looking at software, no actual hardware connected, maybe it changes when connected.
Thank you! Your webinar registration is complete.
Look out for an email with your unique access code and details on how to join.
We look forward to seeing you soon!