hello, does anyone experienced how to read the actual firmware status of the polytune3?
to check the Firmware of your PolyTune3 proceeds as follows:
1) connect a jack cable to the PT input
2) now press + hold the 2 little "Tunig" and "Display" buttons on the back and insert the power connector
3) The display will now show the installed firmware revision number after it starts up : should be "1132"
4) now you are in front test mode and you can either just power cycle the pedal or run through the front test (check of LEDs switches etc):
-> press foot switch once -> press display button 17 times -> Press tuning button 11 times and then the footswitch once which will reboot your pedal
Best regards and have a nice weekend,