Firmware G3.2.6 is now available for PRO1, PRO2, PRO2C, and PRO X!

Triber Contributor
Dear all,

We're pleased to announce the release of Version G3.2.6 for PRO1, PRO2, PRO2C, and PRO X consoles.

Full Public Release for PRO1, PRO2, PRO2C, and PRO X
This document constitutes a formal public release of software for PRO1, PRO2, PRO2C, and PRO X. This build can be made fully available to the public.

Addressed Issues:
• DSP role redeployment hardware failure (previously only worked on software failure)
• Matrix 8 phase corrected
• Date & Time on DSP synchronised to MC Date and Time at boot-up of console
• DL251/252/351 Fixed issue where comms could be lost under certain circumstances with redundant cable confi gured
• FPGA updated to correct a timing issue for MIDI

Additional information
N.B. When updating the date or time via the console GUI (Configuration page) the changes will only synchronise with the DSP on re-powering the console.

Update Procedure
Regular update procedure for PRO1, PRO2, PRO2C and PRO X.
4 Comments
Contributor - Level 2
Chase I do not see it on the Pro2 downloads yet, Am I looking in the right place?
Contributor - Level 2
Contributor - Level 2
Some days ago G3.2.6 disappeared from Pro1 downloads???
Contributor - Level 2
... and today it's up again ... what happened?