Firmware G3.4.3 is now available for PRO1, PRO2, PRO2C, and PRO X!

Triber Contributor
Dear all,

We're pleased to announce the release of firmware G3.4.3 for PRO1, PRO2, PRO2C, and PRO X consoles!

Version G3.4.3
This document constitutes a formal release of Pro 1/2/2C/X software for public usage.

No new features - this is a bug fix release only

• Addressed intermittent issue where one of the Neutron DSP cards could report issue at boot-up and remain in a red status
• Fixed an issue which could cause a limited combination of FX to crash and reboot
• Fixed an issue where surface channel selection buttons would stop responding after selecting a POP or VCA group while in output assign mode (Flip mode with output channel depressed) from the surface.
• Fixed an issue where GEQ for Monitor B could incorrectly control Monitor A under certain conditions
• Value for gain on Loudspeaker Processor now matches with assignable control value
• VCA select from surface indication now works in area B


Use regular update procedure for all Pro series updates