Contributor - Level 1

Connecting xr18 to my hp laptop

I have a message at the top of my xair edit page that says (not connected). I have it plugged into the CR 18 using a ethernet cable. What am I doing wrong?

Brad measel
BradMeasel Contributor - Level 1 2019-11-24

2019-11-24

Connecting xr18 to my hp laptop

I have a message at the top of my xair edit page that says (not connected). I have it plugged into the CR 18 using a ethernet cable. What am I doing wrong?

Highlighted
Rising Star - Level 3

Re: Connecting xr18 to my hp laptop

Hi Brad ( @BradMeasel ), 

 

Welcome to the community.  The XAir Edit app does not automatically connect to your mixer when you first start it. Click on "Setup" in the upper-right corner of the app. Click on "Connection" and notice the status says "disconnected". Click on your mixer in the list on the Left and click "Connect" in the upper-right of the window.  Select your Sync preference, which is typically "Mixer->PC" and you should be connected. 

 

After that, every time you start up XAir Edit it will ask you if you want to connect and sync. 

 

Hope this helps, 

Ken

 

If you want "Loud", then run a piece of sheet metal through a table saw. --Ivan Beaver