Highlighted
Contributor - Level 1

Eurolight 2412 - Using more than 24 dmx addresses

According to the manual for the LC2412 section 8.2.2 "This in no way means you can only control 24 lighting elements"

Therefore consider the following scenario :

8 pairs of led par cans, each pair sharing a dmx address and requiring 3 dmx addresses per pair (R,G,B) so dmx channels for 8 pairs in use are 1 to 24 in sets of three
e.g. first pair uses dmx addesses 1,2 and 3


A ninth pair of led par cans with addresses (say) 101-103


The first three sliders in PRESET A set to send on dmx channels 1/101; 2/202; 3/303


Now, can someone please explain to me how I can send commands to to the ninth pair (dmx addresses 101,102,103) without affecting the pair using dmx addresses 1,2 and 3


I presume I could set up a PRESET on memory slider M1 in a bank but I can't see how to restrict the dmx addresses to which the signals are sent to 101,102,103.

Cambray Contributor - Level 1 2019-11-18

2019-11-18

Eurolight 2412 - Using more than 24 dmx addresses

According to the manual for the LC2412 section 8.2.2 "This in no way means you can only control 24 lighting elements"

Therefore consider the following scenario :

8 pairs of led par cans, each pair sharing a dmx address and requiring 3 dmx addresses per pair (R,G,B) so dmx channels for 8 pairs in use are 1 to 24 in sets of three
e.g. first pair uses dmx addesses 1,2 and 3


A ninth pair of led par cans with addresses (say) 101-103


The first three sliders in PRESET A set to send on dmx channels 1/101; 2/202; 3/303


Now, can someone please explain to me how I can send commands to to the ninth pair (dmx addresses 101,102,103) without affecting the pair using dmx addresses 1,2 and 3


I presume I could set up a PRESET on memory slider M1 in a bank but I can't see how to restrict the dmx addresses to which the signals are sent to 101,102,103.

  • 0 Kudos
  • 0 Replies
  • Reply