Highlighted
Contributor - Level 1

Connect both X-Touch and X-Touch Extender to control X-Air XR18

Hi !

I'd want to control my XR18 with both X-Touch and X-Touch Extender connected together on the router (with RJ45 cable) or connected themselves by USB. Is it possible ? Of course, without using a computer !!! I'd just like to use 17 faders in place of 9 !

Thanks a lot for your ideas ... !

And sorry for my poor english !

Best regards,

Jean-Pascal PERALES
jppinbdx Contributor - Level 1 2020-02-03

2020-02-03

Connect both X-Touch and X-Touch Extender to control X-Air XR18

Hi !

I'd want to control my XR18 with both X-Touch and X-Touch Extender connected together on the router (with RJ45 cable) or connected themselves by USB. Is it possible ? Of course, without using a computer !!! I'd just like to use 17 faders in place of 9 !

Thanks a lot for your ideas ... !

And sorry for my poor english !

Best regards,

  • 0 Kudos
  • 2 Replies
  • Reply
Highlighted
Rock Star - Level 2

Re: Connect both X-Touch and X-Touch Extender to control X-Air XR18

HI @jppinbdx , 

 

Welcome to the community.  Unfortunately, it is currently not possible to use the XT Extender to control an XAir mixer.  A firmware update to add XCTL protocol support would be needed. I "heard" it was in the plans, but have never heard an ETA. 

 

Ken

If you want "Loud", then run a piece of sheet metal through a table saw. --Ivan Beaver
Contributor - Level 1

Re: Connect both X-Touch and X-Touch Extender to control X-Air XR18

Thanks a lot ! So I'll be patient !

Jean-Pascal PERALES