Contributor - Level 2

x32 xlive osc recording

anyone know how to start and stop xlive recording via osc?

StewartJohnson Contributor - Level 2 2019-10-24

2019-10-24

x32 xlive osc recording

anyone know how to start and stop xlive recording via osc?

  • 0 Kudos
  • 5 Replies
  • Reply
Super Contributor - Level 2

Re: x32 xlive osc recording

@StewartJohnson 

See page 64 of Patrick Maillot's X32 OSC Documentation

 

The command is: /‐stat/urec/state {enum}

 

Contributor - Level 2

Re: x32 xlive osc recording

Hi Rex I tried that one, and the mixer did not react..   /‐stat/urec/state

with a 3 (to start recording) 

have you done this successfully?

Super Contributor - Level 2

Re: x32 xlive osc recording


@StewartJohnson wrote:

Hi Rex I tried that one, and the mixer did not react..   /‐stat/urec/state

with a 3 (to start recording) 

have you done this successfully?


@StewartJohnson 

Did you send the command as: /-stat/urec/state ,i 3

 

You may also need to set some /prefs - see page 56.

 

Try sending the commands using Patrick's X32_Command tool to check you have the correct syntax. 

Volunteer Moderator

Re: x32 xlive osc recording


@StewartJohnson wrote:

Hi Rex I tried that one, and the mixer did not react..   /‐stat/urec/state

with a 3 (to start recording) 

have you done this successfully?


What app are you using to send the OSC command? I just checked Live Toolbox source code and that is what I'm using and it works. As Rex @RexBeckett mentioned you may need to include the type (,i) for it to work.

 

Paul Vannatto, Volunteer Forum Administrator and Moderator. Did you find my post helpful? Give kudos or mark it as a solution!
Contributor - Level 2

Re: x32 xlive osc recording

Thanks Guys you all are amazingly helpful.

I had a small typo!!!

Got it working last night.