Hello all so I am running a behringer x32 and one s16. I recently needed to move my s16 so my antennas could be in a more ideal location so my director bought a 75 ft cat6 and when setting it up as normal the aes50 a light on the s16 didn’t even light up I’ve read things about it flashing red and what not but I got nothing. I moved it back to the normal spot and then swapped cables and rebooted and then the light turned on but then on the board on channels 1 through about 8 were only receiving music audio and no vocals. Once the light turned back on the aes50 indicator on the x32 said x32 as opposed to normally saying s16. So with this I figured that the master slave had switched so I reset everything and made sure the s16 was the slave but after doing that the light disappeared so I’m back where I started. I’ve looked about everywhere for the issue online and no luck, me and the sound guy for the church that runs in here have never had the issue either. I have no idea if this forum is still active but we open tomorrow and any feedback would be greatly appreciated.