New to the group and using the XAir 18. I have two challenges when using X Air Edit: 1) When setting up a monitor mix to one of the 6 Buses, when I adjust one of the sliders, in setting levels on one of the buses, it effects the volume coming out of the Main LR. *** Reading though the numerous posts here, I might have solved this one but I haven't tried it out using the mixer. I am at the office using the X Air Edit in off line mode. I believe that challange is solved by clicking one of the 6 Buses on the right side under Main LR, then selecting the master Bus fader. I then would select the channel from the top and then deselect the orange LR under the Main Out? 2) The other challenge that I have is that I am unable to operate the sliders when adjusting the each individual channel bus levels. The channel bus levels mimic what is set using the Main LR levels. I should be able to operate the sliders independently when adjusting the Bus mixes from the Main LR mix?. Does the sliders not functioning in adjusting the Bus mode have to do with each individual channel, send at the top? I have mine all set to INPUT. I want to be able to adjust the level of the monitor mixes for each Bus using the sliders and adjust the MAIN LR levels using the sliders. I am attaching my SCN file. Thanks in advance!