@DaveMorrison do you know much about spek readings? The reason I got the interface initially was to improve the readings I got in the spectrum, as I had intereference at 16k on every rip I had tried. This pic is one I just did with your help Do you know how to help this problem? It does this in all quality exports (16-32-bit, 44-192kHz)
Turntable: Sansui SR-212 (1974) built-in rca > receiver input Receiver: Toshiba SA-320 (1977) rca male > 6.35mm input to insert 1 and 2 on interface rear Audio Interface: Behringer U-Phoric UMC204HD Recorded in Audacity 2.3.3 on Windows 10 Drivers are installed and microphone drop down in Audacity lists the input 1 and 2 (and also lists out 1-2 and out 3-4). Unless I've foolishly overlooked a basic setting, everything should be set. UMC control panel doesn't help at all in guessing what may be wrong. I know the insert 1 and 2 inputs work, I tested on a previous cable that was male rca>male rca and split to 3.5mm and adapted to a single 6.35mm where I got left or right when testing a rip. Please help me out, I'm new to interfaces.