Hello everyone,, I used VoiceSupport2 on my Mac to update the firmware on my FX150. The unit was recognized and everything seemed to go smoothly until the very end when all the buttons/lights began to flicker softly. I get the message that it's in use by other software, and have tried troubleshooting this with no success. I've also tried holding down all the 'Level' buttons as I start up, this causes all the lights to flash regularly. That's about all I can do from my Mac. Mobdro Lucky Patcher Kodi When I attach it to a Windows notebook it is recognized, but again the same message that it's in use by other software shows up. When I try to update the firmware the lights then change blinking pattern until the very end when they all dim slightly and flicker softly. Anyone else out there seen an issue like this? I think maybe it's bricked...
I managed to accidentally get this working once and now it refuses to work again. Simple setup.
Apple TV optical --> DEQ2496 Optical in. --> Optical speaker.
I select Digital as the input.
I've selected everything once as the output. And I can't get it to play on the speaker.
I can plug the apple TV --> speaker and it plays fine.
I can tell by the meters that the DEQ2496 is getting input signals and when I cycle through the meters menu it says it is playing on both the main XLRs and the digital out (I cheat by selecting different things as the RTA even though I have an RTA mic and have the RTA meters show me what is going on with each).
How do I get the Digital signal output working. I'm passing it through the DEQ2496 so I can EQ the signal a little. Thanks for any pointers and guidance. I'm not new to doing sound engineering, but this specific setup has me really stumped.