Hello guys im new to the forum and seeking some help I’ll tell you my set up first. Currently have an x32 in a booth running an analog snake to the stage with 8 inputs coming off the snake also have 12 mic inputs plugged directly in the board the we have two active speakers, two passive subs, and two passive wedge monitors all running through the snake, Along with 4 p16’s ran thru ultanet. So what I'm looking to do is replace the analog snake with an s16 but still want my x32 to have channels 1-8 coming from booth 9-16 from stage and 17-20 coming from booth plus I want to route speakers subs and monitor to digital snake. So my question is how to hook up the s16 correctly. My set up I left it on default mode but was concerned about the xlr outputs because before we just used ¼ outputs do I have to reassign this on the x32? Should I not be running the default on the s16 should it be the next option? Using outputs 9-16 since I was told 15-16 are the defaults for your main? Also is there a way to single out the subs instead of being daisy chained?