Thanks for the instructions and code. However, I can't get it into Boot Mode... --Power on the pedal while holding down the footswitch and "Tone" button - this will start the pedal in Boot Mode --The top-right LED on your pedal will blink green for a few seconds, and then blink yellow when ready The LED on the pedal does not blink. Could it be that the foot switch is bad? It makes no "click" sound as I'm used to on pedals. I used an Ohm meter and it goes from open to short when depressed. Not sure if that's normal operation? I appreciate the continued help!
I can't get my HS2 to connect to VoiceSupport2, so hoping there's a "full factory reset" or somehow to refresh the unit without VS2? maybe power combination with button pushes? Thanks for the help!